Unit operation drying, solvent recovery, heating, sterilization, reaction, cooling, decompression drying, etc. The products produced by our company are in the shape of fine powder, fine particle and fine ball, such as flake material, which is suitable for various shapes. In addition, it is also a material with high moisture content, a slurry material and a processing viscous material.
    The equipment is compact due to the heat transfer area per unit volume. With the wedge-shaped blade in contact with the heat transfer surface, a large heat dissipation coefficient and good heat dissipation effect can be obtained by biting in the powder. In addition, a high filling rate of 85% to 90% can be used to increase the heat conduction area. The overlapping two axis wedge wings move with each other to prevent adhesion, and then suppress it. Therefore, the total effective heat exchange effect will always exist. The residence time distribution is narrow without uneven drying. The equipment is compact due to the heat transfer area per unit volume. With the wedge-shaped blade in contact with the heat transfer surface, a large heat dissipation coefficient and good heat dissipation effect can be obtained by biting in the powder. In addition, a high filling rate of 85% to 90% can be used to increase the heat conduction area. The overlapping two axis wedge wings move with each other to prevent adhesion, and then suppress it. Therefore, the total effective heat exchange effect will always exist. The residence time distribution is narrow without uneven drying.    
    For equipment that may run less load, such as a dust collector, it requires a small. In particular, a major advantage for solvent recovery is that inert gas can be used to close the circuit at the same time. Muddy substances with high water content can also be treated with viscous substances. Because it can also reduce pressure and reduce boiling, it can also be dried continuously, such as weak heat substances. Oil can also be used as heat transfer medium at high temperature (290 ℃). The machine is also designed for drying and single cooling.